External Interface; Communication Interfaces: Setting And Function - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung

en
13 Communication interfaces:
Setting and function
192
Name
Main/standby operation:
Error at the partner pump
Main/standby operation: OFF
Main/standby operation:
This pump head is active
Main/standby operation:
Partner pump active
Parallel operation: OFF
Parallel operation: Parallel opera-
tion
Parallel operation: This pump head
active
Parallel operation: Pump partner
active
Table 32: Active influences
In the "Settings" menu
1. "External interfaces".
Possible selection:

External interface

‣ Function SSM relay
‣ Function SBM relay
‣ Function control input (DI1)
‣ Function control input (DI2)
‣ Function analogue input (AI1)
‣ Function analogue input (AI2)
‣ Function analogue input (AI3)
‣ Function analogue input (AI4)
‣ Setting Wilo Net
‣ Setting Bluetooth
Table 33: Selection "External interfaces"
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
Displayed Description
symbols
Twin-head pump is set in main/standby
operation.
This pump head is active due to a fault
at the pump partner.
Twin-head pump is set in main/standby
operation.
Both pumps are inactive in control
mode.
Twin-head pump is set in main/standby
operation.
This pump head is active in control
mode.
Twin-head pump is set in main/standby
operation.
The pump partner is active in control
mode.
Twin-head pump is set in parallel oper-
ation.
Both pumps are inactive in control
mode.
Twin-head pump is set in parallel oper-
ation.
Both pumps are active in parallel in
control mode.
Twin-head pump is set in parallel oper-
ation.
This pump head is active in control
mode. The pump partner is inactive.
Twin-head pump is set in parallel oper-
ation.
The pump partner is active in control
mode.
This pump head is inactive.
In the event of an error at the pump
partner, this pump head will run.
, select