Maintenance Tasks; Intended Use And Misuse; Intended Use; Misuse - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung

2.6

Maintenance tasks

3

Intended use and misuse

3.1

Intended use

3.2

Misuse

Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
• Wear the following protective equipment:
Sealed safety goggles
–
Safety shoes
–
Safety gloves for protection against cuts
–
• Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
• The procedure described in the installation and operating in-
structions for shutting down the product/unit must be strictly
observed.
• Only original parts from the manufacturer may be used for
maintenance and repairs. The use of any non-original parts re-
leases the manufacturer from any liability.
• Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
• All rotating parts must be at a standstill.
• Close the gate valve in the inlet and in the pressure pipe.
• Collect any leakage of fluid and operating fluid immediately and
dispose of it according to the locally applicable guidelines.
• Store tools at the designated locations.
• After completing work, reattach all safety and monitoring
devices and check that they function properly.
The glanded pumps of the Stratos GIGA2.0 series are intended for use as circulators in
building services.
They may be used for:
• Hot-water heating systems
• Cooling and cold water circulation systems
• Industrial circulation systems
• Heat carrier circuits
Installation within a building:
Glanded pumps are to be installed in dry, well-ventilated, frost-proof rooms.
Installation outside a building (outdoor installation)
• Observe permissible environmental conditions and protection class.
• Install the pump in a housing as weather protection. Observe permissible ambient tem-
peratures (see "Technical data" [} 134] table).
• Protect the pump against the effects of weather, for example, direct sunlight, rain and
snow.
• Protect the pump so that the condensate drain openings remain free of dirt.
• Take suitable measures to prevent the formation of condensation water.
Intended use includes compliance with these instructions as well as the information and
markings on the pump.
Any use beyond the intended use is considered misuse and will result in the loss of all liabil-
ity claims.
The operational reliability of the supplied product is only guaranteed for intended use in ac-
cordance with chapter "Intended use" of the installation and operating instructions. The
limit values must not fall below or exceed those values specified in the catalogue/data
sheet.
en
129