Display For Twin-Head Pump Operation - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung

en
12.4 Display for twin-head pump oper-
ation
Radiator – Dynamic Adapt plus
Main/standby operation
Fig. 64: Home screen en twin-head pump
partner without a mounted differential pres-
sure sensor
190
pump".
Appropriate twin-head pump partners are pumps of the same type.
When the twin-head pump partner is selected, the display of this twin-head pump partner is
switched on (Focus mode). In addition, the blue LED will flash to identify the pump.
Menu "Disconnect twin-head pump"
When a twin-head pump function is established, it can also be separated. Select "Disconnect
twin-head pump" in the menu.
Menu "Types of DP housing"
The selection of the hydraulic position at which the motor head is installed takes place inde-
pendent of a twin-head pump connection.
The following selection is available in the "Types of DP housing" menu:
• Single pump hydraulic
• Twin-head pump hydraulics I (left in the direction of flow)
• Twin-head pump hydraulics II (right in the direction of flow)
With an existing twin-head pump connection, the second motor head automatically accepts
the complementary setting.
• When the variant "Twin-head pump hydraulic I" is selected, the other motor head auto-
matically adjusts to "Twin-head pump hydraulic II".
• When the variant "Single pump hydraulic" is selected, the other motor head automatically
adjusts to "Single pump hydraulic".
Each twin-head pump partner has its own graphic display, showing the values and settings.
The home screen can be seen on the display of the main pump with a mounted differential
Duty point
SL
pressure sensor, as with a single pump.
Q = 0.0 m³/h
H = 0.0 m
The feature SL is shown on the display of the partner pump without a mounted differential
Measured values:
T fluid = -
pressure sensor in the setpoint display field.
P electr. = 398 W
W electr. = 232.1 kWh
Further settings
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
NOTICE
Activating the twin-head pump connection fundamentally changes vari-
ous parameters of the pump. The pump is then started automatically.
NOTICE
If there is an error in the twin-head pump connection, the partner address
must be reconfigured! Always check the partner addresses beforehand!
NOTICE
Disconnecting the twin-head pump function fundamentally changes vari-
ous parameters of the pump. The pump is then started automatically.
NOTICE
The configuration of the hydraulics must be carried out before establishing
the twin-head pump connection. With twin-head pumps delivered from
the factory, the hydraulic position is pre-configured.
NOTICE
The displayed actual values shown on the display of the pump drive, which
is not in operation, correspond 1:1 to the values of the active drive.