Control Mode - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung

en
Application
Heating
Cooling
Heating & cooling
Drinking water
Basic control modes
Fig. 45: "Heating & cooling" application se-
lection
176
Heating & cooling application
The "Heating & cooling" application combines both the applications if both heating and
cooling occurs in the same hydraulic circuit. The pump is set separately for both applications
The pump is used
alternately
for both
and can switch between both applications.
heating and
cooling. The
control mode can be set
separately for
the two
In the "Settings" menu
applications.
1. "Set control mode"
2. "Setting assistant"
3. "Heating & cooling"
Settings help
Select the control mode for the "Heating" application first.
System types for heating application
‣ Radiator
‣ Underfloor heating
‣ Ceiling heating
‣ Fan heater
‣ Concrete core heating
‣ Hydraulic shunt
‣ Differential pressure-less distributor
‣ Buffer heating
‣ Heat exchanger
‣ Heat source circuit
(heat pump)
‣ District heating circuit
‣ Basic control modes
Table 22: Selection system type and control mode for "Heating" application
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
, select the following in turn:

Control mode

Differential pressure Δp-v
Dynamic Adapt plus
Hall temperature T-const
Differential pressure Δp-c
Dynamic Adapt plus
Hall temperature T-const
Differential pressure Δp-v
Dynamic Adapt plus
Hall temperature T-const.
Differential pressure Δp-c
Dynamic Adapt plus
Feed/return ΔT
Volume flow cQ
Sec. feed temperature T-const.
Return ΔT
Multi-Flow Adaptation
Volume flow cQ
Multi-Flow Adaptation
Volume flow cQ
Sec. feed temperature T-const.
Feed ΔT
Multi-Flow Adaptation
Volume flow cQ
Feed/return ΔT
Volume flow cQ
Differential pressure Δp-c
Differential pressure Δp-v
Index circuit Δp-c
Differential pressure Δp-c
Differential pressure Δp-v
Index circuit Δp-c
Dynamic Adapt plus
Volume flow cQ
Temperature T-const
Temperature ΔT-const.
Speed n-const.