Battery Change - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung
Vorschau ausblenden
Andere Handbücher für Wilo-Stratos GIGA2.0-I:
- Montageanleitung (216 Seiten) ,
- Einbau- und betriebsanleitung (144 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
Fig. 106: Remove the module fan incl. cable
and rubber sealing
19.2.5
Battery change
Fig. 107: Dismantle the module cover; release
the display and control unit from the locking
mechanism
234
4.
Remove the module fan and loosen the cable with rubber sealing from the module lower
part.
Installation of the new module fan:
1.
Install the new module fan in reverse order, as described above.
2.
Refit the electronic module (see section "Replacing the electronic module" [} 232]).
Before carrying out any work, disconnect the unit from the power supply and secure it
against being switched back on!
The battery (button cell CR2032) is positioned under the display.
1.
Remove the electronic module cover (see section "Replacing the electronic module"
[} 232]).
2.
Release the display and control unit from the locking mechanism (image) and remove
the display cable.
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
Werbung
Inhaltsverzeichnis
