Installing/Dismantling; During Operation; Maintenance Tasks; Operator Responsibilities - Wilo DrainLift WS 40E Basic Einbau- Und Betriebsanleitung

2.7

Installing/dismantling

2.8

During operation

2.9

Maintenance tasks

2.10

Operator responsibilities

3

Application/use

3.1

Intended use

Installation and operating instructions Wilo-DrainLift WS 40/50 Basic
Application/use
ƒ
Observe the swivel range.
ƒ
Ensure a second person is present to coordinate the procedure if required (e.g. if the
operator's field of vision is blocked).
ƒ
Standing under suspended loads is not permitted. Do not move suspended loads
over workplaces where people are present.
ƒ
Wear the following protective equipment:
–
Safety footwear
–
Safety gloves for protection against cuts
ƒ
Locally applicable laws and regulations on work safety and accident prevention must
be complied with.
ƒ
Disconnect device from the mains and secure it against being switched on again
without authorisation.
ƒ
Close the inlet and pressure pipe.
ƒ
Ensure enclosed spaces have sufficient ventilation.
ƒ
When working in enclosed spaces, a second person must be present for safety reas-
ons.
ƒ
Toxic or asphyxiating gases may build up in enclosed spaces or buildings. Observe
protective measures in accordance with work regulations, e.g. carry a gas detector
with you.
ƒ
Clean the device thoroughly.
WARNING! Risk of fire if inappropriate clothing is worn and highly flammable
cleaning agents are used!
Static charging may occur when cleaning plastic parts. There is a risk of fire! Only
wear anti-static clothing and do not use highly flammable cleaning agents.
ƒ
Open all gate valves in the inlet and pressure pipe!
ƒ
The maximum inflow must be lower than the maximum output of the system.
ƒ
Do not open the inspection openings!
ƒ
Ensure aeration and venting!
ƒ
Wear the following protective equipment:
–
Sealed safety goggles
–
Safety gloves for protection against cuts
–
Safety footwear
ƒ
Disconnect installed products from the mains and secure against unauthorised re-
start.
ƒ
Close the inlet and pressure pipe.
ƒ
Carry out maintenance work according to the instructions of the installed products.
ƒ
Only carry out maintenance tasks described in these installation and operating in-
structions.
ƒ
Only original parts of the manufacturer may be used. The use of any non-original
parts releases the manufacturer from any liability.
ƒ
Collect any leakage of fluid and operating fluid immediately and dispose of it ac-
cording to the locally applicable guidelines.
ƒ
Provide installation and operating instructions in a language which the personnel can
understand.
ƒ
Make sure that the personnel have received the required training for the specified
work.
ƒ
Provide protective equipment. Ensure that the protective equipment is worn by per-
sonnel.
ƒ
Ensure that safety and information signs mounted on the device are always legible.
ƒ
Train the personnel on how the system operates.
ƒ
Eliminate any risk from electrical current.
ƒ
Demarcate and cordon off the working area.
Observe the following points when handling the device:
ƒ
Use is not permitted for persons under the age of 16.
ƒ
Persons under the age of 18 must be supervised by a technician!
ƒ
Use is not permitted for persons with limited physical, sensory or mental capacities!
Pumping of sewage:
ƒ
In cases where sewage cannot be led to the sewer system via a natural fall.
en
41