Maintenance Tasks; Operator Responsibilities - Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung

2.6

Maintenance tasks

2.7

Operator responsibilities

Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
• Make sure that there is no risk of explosion when carrying out
any type of welding work or work with electrical devices.
• Wear protective equipment:
Sealed safety goggles
–
Safety shoes
–
Safety gloves for protection against cuts
–
• Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
• The procedure described in the installation and operating in-
structions for shutting down the product/unit must be strictly
observed.
• Only perform the maintenance work described in these installa-
tion and operating instructions.
• Only original parts from the manufacturer may be used for
maintenance and repairs. The use of any non-original parts re-
leases the manufacturer from any liability.
• Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
• All rotating parts must be at a standstill.
• Close the gate valve in the inlet and in the pressure pipe.
• Collect any leakage of fluid and operating fluid immediately and
dispose of it according to the locally applicable guidelines.
• Store tools at the designated locations.
• After completing work, reattach all safety and monitoring
devices and check that they function properly.
• Provide installation and operating instructions in a language the
personnel can understand.
• Make sure that personnel are suitably trained for the specified
work.
• Verify the area of responsibility and individual responsibilities
of personnel.
• Provide the necessary protective equipment and make sure
that personnel wear it.
• Ensure that safety and information signs mounted on the
device are always legible.
• Train personnel with regard to the operating principles of the
system.
• Eliminate risks from electrical current.
• Equip hazardous components (extremely cold, extremely hot,
rotating, etc.) with a guard to be provided by the customer.
• Remove leakages of hazardous fluids (e.g. explosive, toxic or
hot) in such a way that no danger is posed to persons or the en-
vironment. Comply with national statutory provisions.
• Keep highly flammable materials at a safe distance from the
product.
en
119