Stryker PINPOINT T Endoscopic Fluorescence Imaging System PC9000 Benutzerhandbuch Seite 122

Unplug the power cord to the VPI.
Carefully remove the fuse cover with the fuse located next to the three-prong
power connector on the rear panel of the VPI.
Replace the fuse (Littelfuse, 021806.3HXP, 5x20mm, T6.3A L 250VAC) with
the same model or a listed fuse with the same ratings.
Re-install the fuse cover.
If the VPI fails to operate properly again, contact a qualified NOVADAQ service
representative for repair.
116 4-0002428 Rev. J