JÄGER ADwin-Pro II System- Und Hardware-Beschreibung Seite 81

ADwin
Bereich
Burst-Messung durchführen
Wandlung synchronisieren
Grenzwerte überwachen
LEDs einstellen
Interrupts und Event-Eingang
einstellen
ADwin-Pro II Hardware, Handbuch Dez. 2018
Befehle
P2_Burst_Init
P2_Burst_Start, P2_Burst_Stop
P2_Burst_Status, P2_Burst_Reset
P2_Burst_Read
P2_Burst_Read_Index,
P2_Burst_Read_Index
P2_Burst_Read_Unpacked1/2/4/8
P2_Burst_CRead_Unpacked1/2/4/8
P2_Burst_CRead_Pos_Unpacked1/2/4/8
P2_Sync_All, P2_Sync_Enable
P2_Sync_Stat
P2_ADCF_Read_Limit
P2_ADCF_Set_Limit
P2_Check_LED, P2_Set_LED
P2_Event_Enable, P2_Event_Read
P2_Event_Config, P2_Event2_Config
Pro II: Analoge Eingangsmodule
Pro II-AIn-F-8/14 Rev. E
77