Removing The Perc Card From The Internal Perc Riser - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 30. Installing internal PERC riser
Nächste Schritte
1. Connect the cables to the backplane and then route the cables to the cable guiding latch and close the latch.
2. If removed, install the rear drive
3. Install the air shroud.
4. Install the system cover.
5. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
6. Open the drive bays, install
7. Install the power supply
8. Follow the procedure listed in

Removing the PERC card from the internal PERC riser

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the rear drive
10. Remove the internal PERC
Schritte
1. Disconnect the battery cable connected to the PERC card.
2. Pull the PERC card out of the connector on the internal PERC riser.
cage.
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
riser.
system.
Installing and removing system components
www.dell.com/
57