Installing The Rear Drive Cage - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 57. Removing the rear drive cage
Nächste Schritte
Replace the rear drive cage.

Installing the rear drive cage

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. Remove all the rear drives.
11. Disconnect all the cables from the rear drive backplane.
Schritte
1. Lower the drive cage into the system and push the rear drive cage towards the rear of the system, until it is firmly seated.
2. Using Phillips #2 screwdriver, tighten the screws.
Safety instructions.
all drives, and then close the drive bays.
units.
Installing and removing system components 81