Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch Seite 149

Abbildung 129. Removing screws for cable chain base bracket and cable chain side cover
6. Slide drive bay 2 towards the rear of the system until the screws for the left and right white plastic rail stops are visible and remove
them.
7. Disconnect the left control panel cable from the system board and release it from the cable chain base bracket.
Abbildung 130. Removing the left and right rail white plastic rail stops
8. Remove the screws connecting the cable chain rail to the chassis.
9. Extend the drive bays all the way out of the bay area, until there is a gap to remove the cable chain rail.
10. Lift the cable chain assembly out of the system.
Installing and removing system components 149