Installing An Expansion Card Riser - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Nächste Schritte
Install the expansion card riser.

Installing an expansion card riser

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud
10. If installed, remove the rear drive
Schritte
1. If removed, install the expansion cards into the expansion card riser.
2. Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.
3. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Abbildung 102. Installing right low profile riser
Safety instructions.
all drives, and then close the drive bays.
units.
.
cage.
Installing and removing system components 121