5.
Open the drive bays.
Schritte
1. Using a Phillips #1 screwdriver, remove the screws on top of the drive bay 1.
2. Slide the bracket to the right to disengage it from the slots at the bay base in drive bay 1.
3. Lift the bracket away from the system.
Abbildung 51. Removing bay 1 backplane bracket
Nächste Schritte
Replace the drive bay 1 backplane bracket.
Installing the drive bay 1 backplane bracket
Voraussetzungen
Follow the safety guidelines listed in
1. Follow the procedure listed in
2. If installed,
remove the front
3.
Remove all the drives from drive bay 1.
4.
Open the drive bays.
Schritte
1. Align the backplane bracket with the two slots at the bay base in drive bay 1.
2. Slide the bracket to the left until it is firmly seated and locks into place.
3. Using a Phillips #1 screwdriver, tighten the screws on top of the drive bay to secure the bracket.
Safety
instructions.
Before working inside your system.
bezel.
Installing and removing system components
75