Optional Internal Usb Memory Key; Replacing The Optional Internal Usb Memory Key - Dell Emc Poweredge R740Xd2 Installations- Und Servicehandbuch

8. Follow the procedure listed in
9. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
10. Enter the correct time and date in the System Setup Time and Date fields.
11. Exit the System Setup.

Optional internal USB memory key

ANMERKUNG: To locate the internal USB port on the system board, see the
section.

Replacing the optional internal USB memory key

Voraussetzungen
VORSICHT: To avoid interference with other components in the server, the maximum permissible dimensions of the
USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. If installed, remove the low profile expansion card
Schritte
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
2. If installed, remove the USB memory key from the USB port.
Abbildung 116. Removing the internal USB memory key
a. USB memory key
b. USB port
3. Insert the replacement USB memory key into the USB port.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
riser.
jumpers and connectors.
system.
Installing and removing system components
System board jumpers and connectors
133