Installing Perc Card Into The Internal Perc Riser - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 31. Removing the PERC card from the internal PERC riser
Nächste Schritte
Replace the PERC card into the PERC riser.

Installing PERC card into the internal PERC riser

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. If installed, remove the rear drive
11. Remove the internal PERC
Schritte
1. Align the PERC card to the guiding pins on the internal PERC riser and push the card in.
2. Route the battery cable around the riser and connect to the PERC card.
58 Installing and removing system components
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
riser.