Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch Seite 148

Abbildung 128. Removing the support bar, cable chain top cover and disconnecting the bay 2 backplane bracket from the
cable chain assembly.
4. Loosen the captive screw for the cable chain side cover and disengage it from the guiding pins below and lift it away from the system.
5. Slide the left side of the system, partially off the table, until the bottom screws for the cable chain base bracket are visible and remove
the screws.
VORSICHT: Make sure the system is placed on a work bench before working for this step, as tilting the system or
placing it on its side on the ground, would risk stressing the chassis or toppling the system, causing damage to
components.
148 Installing and removing system components