Steckplatzpriorität; Removing Expansion Card From The System Board - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Tabelle 18. Riser-Konfigurationen: Butterfly-Riser + 3 x flaches Profil – Prozessor 1 und 2
Kartentyp
LOM-Riser; 2 x 1 G BCM5720L (FXN)
LOM-Riser; 2 x 10 G BCM57416
(BaseT/SFP+) (FXN)
LOM-Riser: Broadcom-25G-Karte, 930PP
RAID – PERC 9/9.14G/10 (extern)
Karte voller Bauhöhe (FH-Karte), Netzwerk
(Broadcom / Intel / Mellanox mit 10G, 25G,
100G / Qlogic DP und QP, 10G, SEP)
BOSS M.2 (SATA) (Dell)
PCIe-SSD-PCIe-Karte (Samsung)
Karte mit flachem Profil (LP-Karte), 10G,
25G, 40G (Broadcom / Intel / Mellanox /
Qlogic mit zwei Ports / Solarflare)
BOSS M.2 (SATA) (Dell)
1G-Karte, Netzwerk (Broadcom/INTEL)
RAID – PERC 9/9.14G (intern)
100G-Karte mit flachem Profil (Mellanox)
Qlogic-Karte mit vier Ports und flachem
Profil
PCIe-SSD, PCIe-Karte (Intel)

Removing expansion card from the system board

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the air shroud.
8. If installed, remove the rear drive
9. If installed, remove the expansion card risers.
10. If applicable, disconnect any cables connected to the expansion card.
Schritte
1. Press and lift up the expansion card retention latch to open.
2. Hold the expansion card by the edges and lift the card to disconnect it from the system board connector.
Steckplatzpriorität
1
1
1
4, 3, 2, 5
2
2
4, 3, 5
4, 3, 5
4, 3, 5
6, 5, 4, 3
Integrierter Steckplatz
4
4, 3
3
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
Maximale Anzahl an Karten
1
1
1
4
1
1
3
4
3
4
1
1
2
1
Installing and removing system components 107