Abbildung 55. Removing the bay intrusion switch
Nächste Schritte
Replace the bay intrusion
switch.
Installing bay intrusion switch
Voraussetzungen
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If installed,
remove the front
4.
Open the drive bays.
5.
Remove the drive bay 1 bracket.
Schritte
1. Align the intrusion switch to the intrusion switch slot in drive bay 1.
2. Using a Phillips #1 screwdriver, replace the screws to secure the intrusion switch.
3. Connect the intrusion cable to the backplane of drive bay 1.
Safety
instructions.
Before working inside your
bezel.
system.
Installing and removing system components
79