Removing An Expansion Card Riser - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 97. Installing expansion card on system board
Nächste Schritte
1. Connect the required cables to the expansion card.
2. If removed, install the rear drive cage.
3. Install air shroud.
4. Install the system cover.
5. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
6. Open the drive bays, install
7. Install the power supply
8. Follow the procedure listed in

Removing an expansion card riser

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the rear drive
10. Disconnect any cables connected to the expansion card.
Schritte
Hold the touch points and lift the expansion card riser from the connector on the system board.
118 Installing and removing system components
all drives, and then close the drive bays.
units.
After working inside your
Safety Instructions.
all drives, and then close the drive bays.
units.
cage.
system.
www.dell.com/