Installing Expansion Card On The System Board - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

6. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
7. Open the drive bays, install
8. Install the power supply
9. Follow the procedure listed in
10. Install any device drivers required for the card as described in the documentation for the card.

Installing expansion card on the system board

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. If installed, remove the rear drive
11. If installed, remove the expansion card risers.
Schritte
1. Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. If you are installing a new card, remove the filler bracket.
a) Press and lift the expansion card retention latch.
b) Pull the filler bracket upward out of the system.
116 Installing and removing system components
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
system.
www.dell.com/