Installing The Drive Bay 2 Backplane - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Installing the drive bay 2 backplane

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. If installed, remove the front
6. Open the drive bays, remove
7. Remove the power supply
8. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
9. Open the drive bays.
10. Remove the drive bay 2 brackets.
11. Disconnect all the cables from the backplane.
Schritte
1. Align the backplane to the guiding pins in the bay.
2. Using Phillips #2 screwdriver, tighten all the screws to secure the backplane.
Abbildung 66. Installing bay 2 backplane
Nächste Schritte
1. Connect all the cables to the backplane.
2. Install the drive bay 2 brackets.
3. Close the drive bays.
4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. If removed, install the front bezel.
Safety instructions.
bezel.
all drives, and then close the drive bays.
units.
all drives, and then close the drive bays.
units.
www.dell.com/
Installing and removing system components 87