Intrusion Switch; Removing The Intrusion Switch - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in

Intrusion switch

Removing the intrusion switch

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. Remove the internal PERC
Schritte
1. Disconnect and remove the intrusion switch cable from the system board.
ANMERKUNG: Observe the routing of the cable as you remove it from the system. Route the cable properly when
you replace it to prevent the cable from being pinched or crimped.
2. Using a plastic scribe, slide the intrusion switch from the slot.
Abbildung 37. Removing the intrusion switch
Nächste Schritte
Replace the intrusion switch.
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
riser.
system.
Installing and removing system components
www.dell.com/
63