System Cover; Removing The System Cover - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 20. Installing the front bezel

System cover

Removing the system cover

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide at
www.dell.com/poweredgemanuals.
Schritte
1. Using a 1/4-inch flat head or Phillips #2 screwdriver, turn the lock counterclockwise to the unlock position.
2. Press the release tabs on the system cover, and slide the cover towards the rear of the system.
3. Lift the cover from the system.
Safety instructions.
all drives, and then close the drive bays.
units.
Installing and removing system components 49