Installing The Lom Riser Card - Dell Emc Poweredge R740Xd2 Installations- Und Servicehandbuch

Schritte
1. Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2. Release the two blue plastic clips holding the LOM riser card.
3. Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4. Slide the LOM riser card towards the front of the System until the Ethernet connectors or the Small form-factor pluggable (SFP) are
clear of the slot in the back of the system.
Abbildung 112. Removing LOM riser card
Nächste Schritte
Replace the LOM riser card.

Installing the LOM riser card

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. If installed, remove the rear drive
11. If installed, remove the
Schritte
1. Align the connectors on the LOM riser card with the slot on the system.
2. Press the LOM riser card until the card is firmly seated on the system board connector and the two blue plastic clips hold the LOM
riser card in place.
3. Using a Phillips #2 screwdriver, replace the screws to secure the LOM riser card to the system board.
130 Installing and removing system components
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
risers.