Abbildung 77. Removing the processor bracket
Nächste Schritte
Replace the processor into a processor and heat sink
Installing the processor
Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5.
Open the drive
bays, remove
6. Remove the
power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8.
Remove the system
cover.
9.
Remove the air
shroud.
10. If installed,
remove the rear drive
11. If installed,
remove the
12.
Remove a processor and heat sink
Schritte
1. Place the processor in the processor tray with the connector side facing down.
ANMERKUNG:
Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the
processor.
2. Flex the outer edges of the bracket around the processor ensuring that the processor is locked into the clips on the bracket.
ANMERKUNG:
Ensure that the pin 1 indicator on the bracket is aligned with the pin 1 indicator on the processor
before placing the bracket on the processor.
ANMERKUNG:
Ensure that the processor and the bracket are placed in the tray before you install the heat sink.
module.
Safety
instructions.
all
drives, and then
close the drive bays.
units.
cage.
risers.
module.
Installing and removing system components
101