Installing The Air Shroud - Dell Emc Poweredge R740Xd2 Installations- Und Servicehandbuch

Installing the air shroud

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. If installed, remove the butterfly
Schritte
1. Align the slots on the air shroud with the guide pin on the system.
ANMERKUNG: Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud into the system until it is firmly seated.
Abbildung 25. Installing air shroud
Safety instructions.
all drives, and then close the drive bays.
units.
riser.
Installing and removing system components 53