Abbildung 41. Removing a drive blank
Nächste Schritte
Replace a drive
blank.
Installing a drive blank
Voraussetzungen
1. Follow the safety guidelines listed in
2. If installed,
remove the front bezel.
VORSICHT:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
VORSICHT:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Schritte
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Abbildung 42. Installing a drive blank
Nächste Schritte
If removed,
install the front
Removing a drive carrier
Voraussetzungen
1. Follow the safety guidelines listed in
2. If installed,
remove the front
3. Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator flashes while the drive is turning off. When the drive indicators are off, the
drive is ready for removal. For more information, see the documentation for the storage controller.
Safety instructions.
bezel.
Safety
Instructions.
bezel.
Installing and removing system components
67