Installing The Drive Bay 2 Backplane Brackets - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 53. Removing bay 2 backplane brackets
Nächste Schritte
Replace the drive bay 2 backplane brackets.

Installing the drive bay 2 backplane brackets

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. If installed, remove the front
6. Open the drive bays, remove
7. Remove the power supply
8. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
9. Open the drive bays.
Schritte
1. Align the backplane brackets with the slots at the bay base in drive bay 2.
2. Slide the brackets to the right until the brackets are firmly seated and lock into the place.
3. Using a Phillips #1 screwdriver, replace the screws on top of the drive bay 2.
Safety instructions.
bezel.
all drives, and then close the drive bays.
units.
Installing and removing system components 77