Installing The Rear Drive Backplane - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Installing the rear drive backplane

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. If installed, remove front
6. Open the drive bays, remove
7. Remove the power supply
8. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
9. Remove the drives from the rear drive
10. Disconnect all the cables from the backplane.
11. Remove the rear drive cage.
Schritte
1. Use the hooks on the rear drive cage as guides to align the drive backplane.
2. Lower the backplane into the rear drive cage until it is firmly seated.
3. Using Phillips #2 screwdriver, tighten the screws to secure the backplane to the rear drive cage.
Abbildung 68. Installing the rear drive backplane
Nächste Schritte
1. Install the rear drive cage.
2. Install the drives into the rear drive
3. Connect all the cables to the backplane.
4. Place the system into the rack. for more information, see the Schieneninstallationshandbuch unter www.dell.com/poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. If removed, install front bezel.
8. Follow the procedure listed in
Safety instructions.
bezel.
all drives, and then close the drive bays.
units.
cage.
cage.
all drives, and then close the drive bays.
units.
After working inside your system.
Installing and removing system components 89