Installing The Right Control Panel - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 139. Removing the right control panel
Nächste Schritte
Replace the right control panel.

Installing the right control panel

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. If installed, remove front
8. Remove the system cover.
9. Remove the air shroud.
10. Remove the internal PERC card.
Schritte
1. Route the control panel cable through the right control panel cable clips and push the cable connector through the side of bay 2.
Safety instructions.
all drives, and then close the drive bays.
units.
bezel.
Installing and removing system components 157