Internal Perc Riser; Removing The Internal Perc Riser - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 26. Installing air shroud for system with the rear drive configuration
Nächste Schritte
1. If removed, install the butterfly riser.
2. Install the system cover.
3. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
4. Open the drive bays, install
5. Install the power supply
6. Follow the procedure listed in

Internal PERC riser

Removing the internal PERC riser

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
9. If installed, remove the rear drive
10. Open the cable guiding latch for easy access.
Schritte
1. Lower the plunger and holding the blue touch points, lift the internal PERC riser out of the system.
54 Installing and removing system components
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
cage.
system.
www.dell.com/