Drives; Removing A Drive Blank - Dell Emc Poweredge R740Xd2 Installations- Und Servicehandbuch

Schritte
1. Pull back the blue release tabs on both sides and slide the drive bays into the system, until both the bays lock into place.
Abbildung 40. Closing drive bays
2. If required, lock the drive bay lock located above left release latch, by pushing it down.
Nächste Schritte
If removed, install front bezel.

Drives

Removing a drive blank

Voraussetzungen
1. Follow the safety guidelines listed in
2. If installed, remove the front
VORSICHT: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
VORSICHT: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Schritte
Press the release button, and slide the drive blank out of the drive slot.
66 Installing and removing system components
Safety instructions.
bezel.