Installing Idsdm/Vflash Module - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 108. Removing the optional IDSDM or vFlash card
Nächste Schritte
ANMERKUNG: If you are replacing the IDSDM or vFlash module, remove the microSD cards.
Replace optional IDSDM/vFlash

Installing IDSDM/vFlash module

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud
Schritte
Insert the IDSDM/vFlash module into the system board connector.
126 Installing and removing system components
module.
Safety instructions.
all drives, and then close the drive bays.
units.