Installing Power Interposer Board - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 122. Removing power interposer board
Nächste Schritte
Replace the power interposer board.

Installing power interposer board

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. Disconnect all the cables connected to the system board.
Schritte
1. Press the blue release tab and align the slots on the PIB with the hooks on the PSU cage and slide it into place.
2. Route the cables and connect it to the system board.
Safety instructions.
all drives, and then close the drive bays.
units.
Installing and removing system components 139