Abbildung 54. Installing bay 2 backplane brackets
Nächste Schritte
1. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
2.
Open the drive
bays, install
3. Install the
power supply
4. If removed,
install the front bezel.
5. Follow the procedure listed in
Bay intrusion switch
Removing bay intrusion switch
Voraussetzungen
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If installed,
remove the front
4.
Open the drive bays.
5.
Remove the drive bay 1 bracket.
Schritte
1. Disconnect the intrusion switch cable connected to the backplane of drive bay 1.
2. Using a Phillips #1 screwdriver, remove the screws securing the intrusion switch to the intrusion switch slot.
3. Disengage the intrusion switch from the intrusion switch slot and remove it from the system.
78
Installing and removing system components
all
drives, and then
close the drive bays.
units.
After working inside your
Safety
instructions.
Before working inside your
bezel.
system.
system.
www.dell.com/