Removing An Expansion Card From The Expansion Card Riser - Dell EMC PowerEdge XR11 Installations- Und Servicehandbuch

2. Lower the expansion card riser into place and press the blue target push point that is located on the riser until the expansion
card riser connector is fully seated in the connector.
3. Using Phillips 2 screwdriver, tighten the blue thumbscrew.
4. For Riser 2 and 3, hold the blue touch points on the riser and align the connector with the connector and guide pins on the
system board.
NOTE: Risers 2 and 3 are combined in one expansion card riser.
Figure 65. Installing Riser 2 and 3
5. Lower the expansion card riser into place and press the blue push points on the riser until the expansion card riser is fully
seated in the connector.
6. Using Phillips 2 screwdriver, tighten the blue thumbscrews.
Next steps
1. Follow the procedure listed in
2. Install any device drivers required for the card as described in the documentation for the card.

Removing an expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card risers.
NOTE: The procedure to remove the GPU card and the expansion card is the same for Rear Accessed and Front Accessed
configurations.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the connector on the
expansion card riser.
NOTE: The blue retention latch is only used for when a half-length card is installed. If a shorter card is installed the blue
retention latch is not applicable.
Nach der Arbeit im Inneren des
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres
Systems.
Systems.
Installieren und Entfernen von Systemkomponenten 75