Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch Seite 145

6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. If installed, remove the
11. If installed, remove the rear drive
ANMERKUNG:
• Ensure that your operating system supports the version of the TPM module being installed.
• Ensure that you download and install the latest BIOS firmware on your system.
• Ensure that the BIOS is configured to enable UEFI boot mode.
Info über diese Aufgabe
VORSICHT: Once the TPM plug-in module is installed, it is cryptographically bound to that specific system board. Any
attempt to remove an installed TPM plug-in module breaks the cryptographic binding, the removed TPM cannot be
reinstalled or installed on another system board.
Removing the TPM
Schritte
1. Locate the TPM connector on the system board.
ANMERKUNG: To locate the TPM connector on the system board, see the
2. Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
3. Slide the TPM module out from its connector.
4. Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
5. Pull the plastic rivet out of its slot on the system board.
Installing the TPM
Schritte
1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3. Press the plastic rivet until the rivet snaps into place.
Abbildung 127. Installing the TPM
Nächste Schritte
1. If removed, install the risers.
2. If removed, install the rear drive cage.
3. Install the air shroud.
units.
risers.
cage.
jumpers and connectors
Installing and removing system components
section.
145