4.
Open the drive
bays, remove
5. Remove the
power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7.
Open the drive bays.
ANMERKUNG:
Ensure that the drive bay is fully open to access the backplane.
8.
Remove the drive bay 2 brackets.
9. Disconnect all the cables from the backplane.
Schritte
1. Using Phillips #2 screwdriver, remove all the screws securing the backplane.
Abbildung 64. Removing the screws from the backplane
2. Hold the backplane by the edges and remove it from the bay.
Abbildung 65. Removing bay 2 backplane
Nächste Schritte
Replace the drive bay 2
backplane.
86
Installing and removing system components
all
drives, and then
close the drive bays.
units.