Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch Seite 132

11. If installed, remove the low profile or full height X1 expansion card
Schritte
1. Locate the battery socket.
VORSICHT: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2. Use a plastic scribe to pry out the system battery.
Abbildung 114. Removing the system battery
3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Abbildung 115. Installing the system battery
Nächste Schritte
1. If removed, install the low profile or full height X1 expansion card
2. If applicable, connect the cables to the expansion card(s).
3. If removed, install the air shroud.
4. Install the system cover.
5. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
6. Open the drive bays, install
7. Install the power supply
132 Installing and removing system components
all drives, and then close the drive bays.
units.
risers.
risers.
www.dell.com/