Removing The Right Control Panel - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

6. Open the drive bays, remove
7. Remove the power supply
8. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
9. Remove the system cover.
10. Remove the cable chain
Schritte
1. Align the left control panel assembly with the control panel slot on the chassis and using Phillips #1 screwdriver, replace the screws to
secure the left control panel assembly to the chassis.
2. Route the left control panel cable through the cable channel of the system.
Abbildung 137. Installing the left control panel
3. Connect the control panel cable to the system board connector.
Nächste Schritte
1. Install the cable chain assembly.
2. Close the drive bays.
3. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
4. Install the power supply
5. Open the drive bays, install
6. If removed, install the front bezel.
7. Follow the procedure listed in

Removing the right control panel

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
all drives, and then close the drive bays.
units.
assembly.
units.
all drives, and then close the drive bays.
After working inside your
Safety instructions.
system.
Installing and removing system components
www.dell.com/
155