Optionale microSD- oder vFlash-Karte
Removing the internal micro SD card
Prerequisites
1. Follow the safety guidelines listed in Sicherheitshinweise.
2. Follow the procedure listed in
Steps
Locate the micro SD card slot on the internal dual SD module (IDSDM), and press the card to release it from the slot.
NOTE:
Temporarily label each micro SD card with its corresponding slot number before removal. Reinstall the micro SD
cards into the corresponding slots.
Figure 50. Removing the internal MicroSD card
Next steps
Install internal micro SD card
Installing an internal micro SD card
Prerequisites
Follow the safety guidelines listed in Sicherheitshinweise.
NOTE:
To use an micro SD card with your System, ensure that the Internal SD Card Port is enabled in System Setup.
Steps
1. Locate the micro SD card connector on the internal dual SD module. Orient the micro SD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
NOTE:
Temporarily label each SD card with its corresponding slot before removal.
Vor der Arbeit an Komponenten im Inneren Ihres
Systems.
Installieren und Entfernen von Systemkomponenten
89