Removing The Drive Bay 2 Backplane Brackets - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 52. Installing bay 1 backplane bracket
Nächste Schritte
1. Install all the drives.
2. Close the drive bays.
3. If removed, install the front bezel.
4. Follow the procedure listed in

Removing the drive bay 2 backplane brackets

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. If installed, remove the front
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Open the drive bays.
Schritte
1. Using a Phillips #1 screwdriver, remove the screws on the top of the drive bay 2, securing the backplane brackets.
2. Disconnect the cables of the cable chain assembly connected to the backplane.
3. Slide the brackets to the right to disengage them from the slots on the bay base in drive bay 2.
4. Lift the right bracket away from the system and move the left bracket away from the drive bay.
76 Installing and removing system components
After working inside your
Safety instructions.
bezel.
all drives, and then close the drive bays.
units.
system.