Installing The Intrusion Switch - Dell Emc Poweredge R740Xd2 Installations- Und Servicehandbuch

Installing the intrusion switch

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
5. Open the drive bays, remove
6. Remove the power supply
7. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
8. Remove the system cover.
9. Remove the air shroud.
10. Remove the internal PERC
Schritte
1. Align and slide intrusion switch into the slot in the system.
Abbildung 38. Installing the intrusion switch
2. Connect the intrusion switch cable to the connector on the system board.
ANMERKUNG: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Nächste Schritte
1. Install the internal PERC
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in
64 Installing and removing system components
Safety instructions.
all drives, and then close the drive bays.
units.
riser.
riser.
all drives, and then close the drive bays.
units.
After working inside your system.
www.dell.com/