Optional Idsdm / Vflash Module; Removing The Idsdm/Vflash Module - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

Abbildung 107. Installing the M.2 SSD module
Nächste Schritte
1. Install the BOSS card.
ANMERKUNG: The procedure to install the BOSS card is similar to the installing an expansion card on the system
board.
2. Install the air shroud.
3. Install the system cover.
4. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
5. Open the drive bays, install
6. Install the power supply
7. Follow the procedure listed in

Optional IDSDM / vFlash module

The write-protect switch is on the IDSDM module.

Removing the IDSDM/vFlash module

Voraussetzungen
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
4. Open the drive bays, remove
5. Remove the power supply
6. Remove the system from the rack and place it on an ESD work bench. For more information, see the Schieneninstallationshandbuch
unter www.dell.com/poweredgemanuals.
7. Remove the system cover.
8. Remove the air shroud.
Schritte
Holding the pull tab, lift the IDSDM/vFlash module out of the system board connector .
all drives, and then close the drive bays.
units.
After working inside your
Safety instructions.
all drives, and then close the drive bays.
units.
system.
Installing and removing system components
www.dell.com/
125