Removing The System From The Rack; Replacing The Rack Doors; Two-Post Rack Installation - Dell PowerEdge 860 Installationsanleitung

Removing the System From the Rack

To remove the system from the rack, perform the following procedure:
NOTE:
1 Turn off the system and attached peripherals, and disconnect the system from the electrical
outlet.
2 Disengage the both thumbscrews on the front panel of the chassis.
3 On either side of the system, locate the back release latches.
4 Pull the system out of the rack until it stops, and then push down on both release levers
to actuate the side-rail safety catches (see Figure 1-8).
5 Pull the system completely out of the rack.

Replacing the Rack Doors

See the procedures for replacing doors in the documentation provided with your rack.
CAUTION:
them by yourself.
This completes the rack installation of your system in a four-post rack cabinet.

Two-Post Rack Installation

The two-post rack kit is used to install a system in a two-post, open-frame relay rack, such as those
found in telecommunications equipment facilities. Both 7.62-cm or 15.24-cm (3-inch and 6-inch)
wide two-post racks with universal hole spacing or wide hole spacing are accommodated. You can
install this kit in a center-mount or a flush-mount configuration.
You must properly secure the two-post relay rack to the floor, the ceiling or upper wall, and where
applicable, to adjacent racks, using floor and wall fasteners and bracing specified or approved by
the rack manufacturer or by industry standards. See the two-post rack manufacturer's
documentation for warnings before attempting this installation.
CAUTION:
securely anchored in place. Damage to the system and personal injury to yourself and to others may
result.
See "Safety Instructions" for additional safety information regarding rack installation.
18
Rack Installation Guide
You do not need to remove the optional front bezel to install or remove the system from the rack.
Because of the size and weight of the rack cabinet doors, never attempt to remove or install
Do not attempt to install the system into a two-post, open-frame relay rack that has not been