Idrac Direct Led Indicator Codes; Nic Indicator Codes - Dell Emc Poweredge R740Xd2 Installations- Und Servicehandbuch

System health and system ID
indicator code
Solid amber
Blinking amber

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. The
following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Tabelle 45. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two
seconds and off for two
seconds)
Powers off

NIC indicator codes

Each NIC on the back of the system has indicators that provide information about the activity and link status. The activity LED indicator
indicates if data is flowing through the NIC, and the link LED indicator indicates the speed of the connected network.
Abbildung 145. NIC indicator codes
1. Link LED indicator
2. Activity LED indicator
Tabelle 46. NIC indicator codes
Status
Link and activity indicators are off.
Link indicator is green, and activity indicator is blinking
green.
Link indicator is amber, and activity indicator is blinking
green.
Link indicator is green, and activity indicator is off.
Link indicator is amber, and activity indicator is off.
Condition
Indicates that the system is in fail-safe mode. If the problem persists, see the Getting help
section.
Indicates that the system is experiencing a fault. Check the System Event Log for specific
error messages. Weitere Informationen zu Ereignis- und Fehlermeldungen, die von der
System-Firmware und den Agenten, die Systemkomponenten überwachen, generiert werden,
finden Sie auf der Seite zum Nachschlagen von Fehlermeldungen auf qrl.dell.com.
Condition
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Condition
The NIC is not connected to the network.
The NIC is connected to a valid network at its maximum port speed, and
data is being sent or received.
The NIC is connected to a valid network at less than its maximum port
speed, and data is being sent or received.
The NIC is connected to a valid network at its maximum port speed, and
data is not being sent or received.
The NIC is connected to a valid network at less than its maximum port
speed, and data is not being sent or received.
System diagnostics and indicator codes 173