8. Align the cable chain top cover to the guiding pins and replace all the screws.
Abbildung 135. Replacing the support bar, cable chain top cover and connecting the bay 2 backplane bracket from the
cable chain assembly.
Nächste Schritte
1. Replace the following:
a.
PIB.
b.
Memory modules for processor 1.
c.
Internal PERC card
d. If installed,
rear drive cage.
e.
Intrusion switch.
f.
Air shroud.
g.
Drive bay 1 bracket.
h.
Drive bay 2 bracket.
i.
Connect all the cables to the backplane and system board.
2. Install
the system
cover.
3. Place the system into the rack. For more information, see the Schieneninstallationshandbuch unter
poweredgemanuals.
4.
Open the drive
bays, install
5. Install the
power supply
6. If removed,
install front bezel.
7. Follow the procedure listed in
Control panel
Removing the left control panel
Voraussetzungen
1. Follow the safety guidelines listed in
all
drives, and then
close the drive bays.
units.
After working inside your
Safety instructions.
system.
Installing and removing system components
www.dell.com/
153