Removing The Drive Bay 2 Backplane - Dell EMC PowerEdge R740xd2 Installations- Und Servicehandbuch

2. If installed, remove front
3. Remove all the drives from the drive slots from bay 1.
4. Open the drive bays.
5. Remove the drive bay 1 bracket.
6. Remove the bay intrusion switch.
7. Disconnect all the cables from the backplane.
Schritte
1. Align the backplane to the guiding pins on the bay.
2. Using Phillips #2 screwdriver, tighten all the screws to secure the backplane.
Abbildung 63. Installing bay 1 backplane
Nächste Schritte
1. Install the bay intrusion switch.
2. Connect all the cables to the backplane.
3. Install the drive bay 1 bracket.
4. Install the drives back into their original locations.
5. Close the drive bays.
6. If removed, install front bezel.
7. Follow the procedure listed in

Removing the drive bay 2 backplane

Voraussetzungen
VORSICHT: Note the number of each drive and temporarily label them before you remove the drive so that you can
replace them in the same location.
1. Follow the safety guidelines listed in
2. Power off the system and all attached peripherals.
3. Disconnect the system from the electrical outlet, and disconnect the peripherals.
bezel.
After working inside your
Safety instructions.
system.
Installing and removing system components 85