Configuration example with TIA® Portal
13.5 Initial commissioning, manual control with the monitoring table
It is recommended that the encoTRive be controlled manually for initial
commissioning. This can be achieved with the help of the monitoring table in the TIA-
Portal. This makes it possible to read and write the parameters directly from the
encoTRive.
Figure 36: Manual control with the monitoring table
13.6 Parameterization via PROFINET
For cyclic or acyclic parameterization via PKW or RecordData, use of the available
function blocks with the relevant documentation is recommended.
In detail, these are:
● TR-EMO-TI-DGB-0067,
S7 function block for acyclic parameterization
● TR-EMO-TI-DGB-0068,
S7 function block for commissioning via PZD channel
TR-Electronic GmbH 2008, All Rights Reserved
Page 234 of 252
TR-EMO-SW-DGB-0036
TR-EMO-SW-DGB-0034
TR - EMO - BA - DGB - 0019 - 08
Printed in the Federal Republic of Germany
06/06/2019